Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
Has anyone configured transparent WCCP redirection on Cisco FTD managed by FMC? I couldn't find any online referrals for this. Appreciate the expert help.
Thank you
Nimalraj
Hello Experts,
I have 2 x FTD2110 configured in HA and they managed by FMCv. Both FMC and FTD are running on code 6.2.2.
I have configured a PBR with 'match list' and a 'set next-hop' command and was able push the flexconfig to FTD successfully and P...
Hello there,As all know, OSPF uses 224.0.0.5 and 224.0.0.6 for DB updates. Once the OSPF n/w is converged, the 'show ip interface' command shows the multicast group the router has joined.My question is, when ospf is enabled on a interface, will the r...
Hello everyone,I would like to get the explanation for the following.I have two routers connected with each other and running RIP in between them (Only on directly connected interfaces). On one of the routers there is a static route which is pointin...
Hello guys,I have system which works on Server/Client basis on a specific port number (udp 5000). The Server version of the system is in a remote location where as the client system is installed on more than 1 PC. Our network has a PIX firewall where...
Yes. You need to assign the IP for your port-channel. You need to provide the primary device IP as well as the secondary device IP during the configuration.
Hello, I am experiencing this problem too. In addition, I am getting an alert message saying "Interface Portchannel is not receiving any packets". Did you find the solution?
Thanks
Nim
Hi Vivek, Did you manage to resolve this issue. I am experincing the same issue. If you could give some information about the troubleshooting steps, it will be really helpfull.ThanksNP
