Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I have an issue with a 9115E AP where for 2.4 radio is active only B connector. The question is how to activate others 4 connectors.
Is this model has any limitations?
My installation and AP use is that two antennas are installed in two differe...
I have a 9200L switch with 16.9.5 software version and want to run 802.1x on a port where phone and PC are connected.The phone and PC are successful authorize on separate ports but when they are connected together, switch authorize only phone. Wiresh...
Hello,I have a little issue to configure policy to TACACS+ device authentication to authorize users from local and AD users on one policy.In first policy when the user is not found in local store then the second option is not taken - AD Domain.If use...
Hello,
I had a situation where stack of two 9300 switches was upgraded from 16.06.03 to 16.06.05 and it couldn't boot up properly.
The upgrade procedure was always the same, place the new image on USB flash and run command request platform software a...
I have an issue to upgrade Cisco Phone 8851 to third-party call control software.
I don't have a CUCM and my configuration is done by xml config files only.
The issue is that the phone reads the file sip88xx.10-3-1-9-3PCC.loads from TFTP server but n...
Hello,
The command password encryption aes is not available on C1000 platform because the symmetric AES keys are not supported.
The device supports the Advanced Encryption Standard (AES) encryption algorithm with a 128-bit key, 192-bit key, or 256-bi...
@Rich R @JPavonM
My sentence is based on testing purpose and that is true. The second part of sentence is from Cisco technical solution architect of local office (it's starts from ....Both 9115, 9120 and 1850) and that is true based on official da...
Hello guys,
thank for all us to interest in this thread and some explanation.
Cisco AP 9115E and 9120E transmit 2.4GHz radio only on connector B, there are no information in Cisco documentation about it.
We recreated the communication tests which con...
Hello @Leo Laohoo
We have tested on all four antenna connected and when one antenna from B connector was detached, the 2,4 signal was very poor.
This solution worked on 1852E, where two antennas was installed in separated rooms and connected to A an...
