Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About sebastian.wieseler
Stats
Member since
09-04-2012
18
Posts
0
Helpful
0
Solutions
10-30-2012
Hello supportforum memebers,Does anybody know what hardware in the NCS
appliance (http://www.cisco.c...
10-25-2012
and why 500 mbps? The bandwith of one connection (okay, half duplex)
should be 1.3 gbps nevertheless...
10-25-2012
3600 series should make 3x3:3 - this would be a netto bandwith of 1.3
gbps. Where did your 500 mbps ...
10-24-2012
Hello,I noticed that the 3600 access point series will get an add-on
module to support 802.11ac. Thi...
09-06-2012
lol. While restoring the backup my virtual machine ran out of memory...
and accessing it back throug...
09-06-2012
Allright. I will come back to you in some hours. *restoring my backup
first and then going back down...
09-06-2012
Hmmmm.. I did the same... 1.1.1.24 to PI 1.2. :-\Now I am frustrated and
did a ncs db reinitdb. Mayb...
09-06-2012
Hello.I followed the instructions of the Quick Start Guide but after
"application upgrade" I cannot ...
09-05-2012
In the "download area" of cisco.com you only have the choice between 1.1
and 1.0. There is no 1.2
09-05-2012
What's your wireless controller firmware version? Or is this
anautonomous access point szenario?
09-05-2012
Yep. Access Points in local mode are not supported, so it should be less
load for the vWLC. But it's...
09-05-2012
Yep! It runs quite good And thanks for the information! I guessed the
NCS would be out earlier with ...
09-05-2012
Hello community,Does anybody know when the NCS will support a vWLC? At
the moment it is still an "un...
Public Statistics
| Date Registered | 09-04-2012 01:45 AM |
| Date Last Visited | 08-18-2017 03:53 AM |
| Total Messages Posted | 18 |
.jpg "VIP Community Legend"){kind=icon}
