Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Folks,I was working on a route leaking on Fusion switch in SDA deployment where I need to leak specific routes from a VRF to the Global Routing Table.I’ve used import ipv4 unicast map and export ipv4 unicast map under the VRF configuration.Prefix...
I just prepared a small setup with 2 separate borders with LISP Pub/Sub and Nexus Switch as Fusion. On Fusion switch I have a network 172.16.1.0/24 with SVI IP 172.16.1.1 on GRT.Injected a route (172.16.1.0/24) from Fusion Global Routing table to Bor...
Hello Everyone,We are building an SDA network with two separate border and control plane nodes ( collated both roles on same device) that are connected by BGP to a fusion firewall (Active/Standby). When DNAC configures the L3 border handoff, I provid...
We are deploying the similar design as shown in the attached picture ( source: Cisco Live) where we have Nexus vPC switch as L3 hop between Border and Firewalls.BGP sessions will be established directly between:Border Nodes and NexusNexus & Firewalls...
Trying to deploy VNs to the fabric devices, but when I reach the preview configuration step, it shows "no devices found." The VN has already been created and assigned under the fabric site.Some quick checkupFabric devices (Border Nodes, Control Plane...
Thanks @Andrii Oliinyk I guess figured it out. I think it is normal edge to not ping any external destination using an overlay interface/anycast gateway. Anycast gateway on edge is the loopback IP on the Border so kind of duplication.I am not sure to...
