Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I have the following scenario and i need your assistance in order to comple my installation.I have a Cisco 1720 connecting my company to the frame relay network. I have a multi branch company whom i have already data running over the frame...
Hi I have a PIX 515 UR IOS version 6.1(1). I installed PDM 112 and it went ok. I tried to connect to the device via https://IP_address and i was not able. what would be the problem? do i have to restart PIX? or i am missing somethingthx for your time...
Hi Well there is a policy on our network to deny Kazaa from being used, i tried to use an access list to block port 1214 and applied it on the outside interface as incoming traffic and it did not work. Same as on the internal network. Also i found ou...
Good dayI have two 3662 routers that connect the main campus to another one. My internet connection is via Frame Relay. The case we are dealing with now, is that we got an E1 line that will be installed before the week-end and we need to test the con...
Good dayi have a Pix installed in my network and it is up and running perfectly. I assigned a password for the telnet and yet can not telnet the device from the internal network. Is there any additional command to enable telnet on it from the inside?...
Daniel,You have to be sure to remove the live in the access list because if you did not so, the new rule will NOT override the old one and there would be two rules which might cause a conflict on your network.RegardsWael
Hi well as far as i see, it is a case that can be done with two small commands on the Pix Firewall.First you have to map the IP address of the server located on the inside network (private addressing) with an global IP address (real IP) using this c...
Can you provide with your config of the devices, u can fake ur IPs if your don't want to show your real ones. In this way we could help you better. Also what are the components you are using, Router model (is the inside a router or layer 3 switch) an...
Well 2 cases can happen:1- if you don't have a layer 3 switch on the inside network, then the firewall should be your default gateway.2- If you do have a layer 3 switch, you will have a fixed ip per subnet on the switch (defined manually), and then y...
