Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have problem with the PIX Firewall 515 running 6.3(1). I can not use the VPN Client behind any NAT or PAT firewall. I make a connection but can not pass any traffic to my private addresses. I am using the command :isakmp nat-traversal Still no su...
I am trying to use the new IPSec Transparency VPN. I have a Cisco 3620 router using this bin file c3620-ik9o3s3-mz.122-13.T1.bin. What happens is anytime I apply an access list to the serial interface even if it says permit ip any any, the vpn will...
Please help! I am having trouble uninstalling the VPN Client 3.5 software from my computer.As a result it would not let us install any version of the VPN Client properly, because it would not copy the preconfigured files from the installation folder....
I just found some new information. If I ping from the PIX side of network to the VPN Client, the stats say they are decrypting on the client but no ping replys on th PIX side of the network. It is almost like the PIX is the only one that is not dec...
I have used UDP 4500 through my ISP on a router with Nat-T. I am pretty sure it can not be the ISP. The router on it does have an access list. Even when i remove the access list it still does not work. I do not know where this could be being bl...
Yes Packets do start encrypting but do not ever decrypt. I have look at each side client/pix and both sides start encrypting but never decrypt. I do not have anything else blocked on the network for UDP 4500, except what I have put on the PIX Firew...
Thank you for your response. I am currently using VPN Client 3.6.4. When I connect it does show tunnel port UDP 4500. No packets will pass to the network. Everything shows up as Packets Bypassed. This same configuration works as long as I am not...
