Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Please make sure below ports are open on firewall in order to work properly with standalone mode-+++++++++++++++For H.323:Gatekeeper Discovery (RAS) - Port 1719 - UDPQ.931 call Setup - Port 1720 - TCPH.245 - Port Range 5555-5574 - TCP for Stat...
Hello Todd,
The Issue with Chrome 72 is fixed in CMS2.5.1 but if it is still not working that might be some other issue.
if you have the clustered setup did you upgrade the schema after upgrading the servers?
Better to open a TAC case and get the l...
Hello,
So in SIP you will be dialing in URI ( number@domain or ip) format not just IP.
And in H323 you can directly call IP and H323 mode should be Direct not gatekeeper.
So try to set SIP URI and then dial and it should work.
Thanks
Please rate...
Hello,
Once you get that IP along with that you will get a gateway address as well.
So you need to browse the gateway IP address and it will open the IX5000 webGUI and from there you can click on logs then generate logs.
Once the logs are generate...
Hello Siwar,
Please remove the touch 10 and connect your laptop with the same and enable DHCP on your laptop.
You will see a IP assigned by Host CPU in range of 169.254.x.x.
Please try to access through gateway IP and collect the logs first from IX...
