Hello. I have the following configuration and I wonder if I can allow all outgoing traffic without using ip inspect. Perhaps with an outgoing access rule. I want to continue blocking incoming traffic as I do.
Thank you.
version 12.4no service padser...
Hello.
I want to use two adsl lines on 887VA, one directly to dsl interface and the second on lan1 behind my provider's modem (bridge mode) and load balance them.
Is this possible with 887VA router?
Thanks.
Hi Richard. I tried what you told me in both cases. Ip inspect and reflexive lists.
1. In case of ip inspect no ACL change happens.
2. In case of reflexive ACL a dynamically reflexive ACL is created and is alive for a period of time that is set with...
The same thing happens using ip inspect. Not only using reflexive ACLs. The arp tables do not show any temporary created entry. Trying to debug with "debug ip packet detail" I see that before pinging from pc icmp reply is blocked (access denied). If ...
Richard I found out that reflexive access lists is the solution to avoid ip inspect. So everything is ok with that.Investigating more the problem of pinging from router I also realized that router can ping internet addresses for some seconds that had...
Well done ! Great document athukral ! I was wondering if there is another way to avoid ip inspect and this is what I searched for !
I have another problem using your way or ip inspect way. I can ping internet from computers connected to internal NAT...