Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I set up a Site to Site VPN and everything is working fine where, I can access resources from both locations. However, when I connect to the VPN with cisco any connect client I can only access the resources on the 192.168.120.x subnet and not the rem...
Hello all, I am trying to set up a site to site vpn and am not having any luck at getting the connection established. I have configured both firewalls as below but seem to not understand what else I am missing to establish the vpn. I tried originally...
Hello, I am trying to setup my asa for first time use. And I am unable to get to the outside world. I am not sure where I am going wrong with my configuration. Thank you for your help. Here is my current config:
Result of the command: "show run"
: S...
I just got a new ISP and they have their Gateway versus our other ISP which is just basically a modem connected to our firewall. Well we got new Static IPs and i thought if i simply changed all my current static IPs to the new one the switch would be...
Thank you Adam, I forgot it was inheriting from that default group policy. I added in the remote subnet to the nwdls_splitTunnelAcl and I still am unable to access the remote subnet? Anything else I might want to look at?
ciscoasa# show run access-l...
Thank you for your help!
I added a split-tunnel-list acl and applied it to the groupolicy NWdlsx64 and i'm still unable to get to the remote network? Did I implement it incorrectly?
Result of the command: "show run"
: Saved:ASA Version 8.4(2) !hostn...
Thank you it was in fact my isp. They had a static arp entry for my old firewall's mac address, once they cleared that, everything was great. I appreciate everyone's help!
Sorry, I just saw this. I tried pinging my default gateway from the ASA and it was unsuccessful. I'm still unsure where I am going wrong?
Thank you
Matt
