Hi,I have added PIX to CSPM with success, added CSPM as host that is sitting on the inside interface. IDS4210 is also sitting on "inside" net, but when Im trying to add IDS, it fails in discovering IDS.nrconns output says syn not rcvdall teh daemons...

HI I have a 3640 router, it has leased lines n a single e1 pri line as backup for leased lines. Its a meashed network of leased lines with all sites connected with atleast 2 mbps pipe. For a single site if all leased lines goes down then it has e1 pr...

Apr 12, 2002, 12:54am PST (2.) HIi have grouped e1 pri as 1-15 n 16-31 using channel-group command, now i want to use these serial interfaces( serial 1/0:1, serial 1/0:16) as backup dial-out interfaces for my primary LLs, i tried creating a dialer in...

HI,I want to devide e1 pri in two groups i.e 1mpbs each,while doing this i have a doubt about signalling channel 15, whts the right way of grouping,channel-group 0 timeslots 1-15channel-group 16 timeslots 16-31is this a right way or i have to exclude...

HI I have a 3640 router, it has 8 MB on board Flash n 8 MB PCMCIA. I have an image that is 10MB, is it possible to logically combine these two so that i can upload 10 MB image. I understand that this is not a platform related question but I dont see ...