Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team, I would like to use gi0/2 as a way to get my internet in from my ISP. The ONT has an Ethernet port on it, that is currently connected to an HWIC-1FE card which provides me with 100 mbps. Since I'm going to upgrade to 500 mbps, and possibly Giga...
Good morning team, I'm upgrading the IOS on my 3945 this morning, and I think I accidentally deleted something I wasn't supposed to. Now I was able to do recovery via ROMMON and the tftpdnld -r command and get the upgraded image loaded into the route...
Good afternoon Team, Long story short, I've had to move a my server to my outside closet where my 3945e is located. Now in my living room I have my main switch setup (4948), and I used to have it connected to that, so I thought "Well since I don't ha...
Good evening team, I am in the middle of configuring my Cisco ISR G2 3945e as my home router. I'm replacing my standard Frontier router with the Cisco router. My problem is that now as I've configured everything, my main computer in my bedroom is the...
Team, I am attempting to update my Cisco IOS version from 12.2 to 15.02 on my 4948 and its giving me serious issues. I have the TFTP server setup properly with port 69 open and the service has started, but everytime I try to do it, it times out. This...
Unfortunatelly that didn't work, as soon as I copied and pasted that configuration and switched the cable over from FE to GI0/2, I lost complete internet connectivity.
