Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hola,Tengo un controlador wifi Cisco 2100 y varios AP 1131, algunos de ellos averiados que necesitaría sustituir, mirando en la web he visto que ya no se fabrican ni los AP ni el controlador que tengo.¿Alguno de los AP actuales son compatibles con el...
Hello everyone.I have a Cisco 2100 WLC with two access points 1130AG in different places. The system is working correctly, but occasionally one of the APs fails. They have the green led, but any client can connect, until I reset the AP with the optio...
Hello everyoneI have a Cisco 2100 WLC with two Access Points 1130, with two WLAN networks, one with WPA2 and the other with Web-Authentication. The two networks works correctly, but I have a client, a Sony Vaio with Windows Vista, which usually give ...
Hello mates.I have configured a Cisco 2100 WLC. I have configured two WLANs, one of them with Web-Authentication. When I connect to it, I get an IP address, and if I open the browser, I was redirected to the authentication page (in the browser toolba...
HelloToday I had the same problem with one of the APs.The leds of Radio and Ethernet are in green light, frequent blinking (I think is right).I connected to the AP with a console cable and I saved this events, before resetting the AP as I mentioned a...
-The version of WLC is AIR-WLC2112-K9 and the firmware is 6.0.196.0.-I can't recover the AP with a normal reset, I need to do a "clear config except static IP".-The APs are in different buildings, but in the same network (the buildings are in the sam...
When you manually enter the address 1.1.1.1, can you validate and surf the web?Check you have the correct DNS and gateway on the clients.After the problems discussed above, switched WLAN interface with web-auth to use another different range of IPs....
Thanks for you help, I removed the DNS name, and it works correctly. Previously, I tried with this configuration, I suppose that I had some other different configuration. I'm very grateful.
