Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pix 515 v6.3. I am tring to use then "debug access-list all" command to see what traffic is being stopped by my access-list. However, I do not get any output. I turn run the command, but nothing happens. Other debug commands do output to...
I am new to SRST. I cannot get my phones to register with the router (2801). I think I am missing a command (maybe to activate SRST?). I haven't put in the dial peers I need yet. I'm just trying to get the phones to register with the router firs...
I just got a 2801 with SRST and need to add it as a voice gateway to Call Manager 4.0. I can add it easily enough as a H.323 gateway, but I would like to add it as a MGCP Gateway (I have no experience with H.323. For that matter I have no experince...
We just added interfaces to our pix so that we could put some servers we are using for hosting in a dmz and seperate them from our internal network. Everything seems to be working except I can't figure out how to allow certain traffic from the DMZ t...
I have a pix 515E with only two interfaces, an inside and an outside, but I need to connect two T1 internet connections on different subnets to the outside interface. I have a Cisco 3550 switch on the outside between the routers and the pix. I've b...
Thank you m.sir. I had forgotten about the terminal monitor command. I am connecting via a telnet (well ssh) session. However, after trying the "terminal monitor" command I still do not get any output. Do I have to turn on logging or something as...
