Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6509 acting as a distribution switch, one of the downliks is an old FO to a small site which every now and then has a small interruption that cause the whole network to recalculate the spanning tree, so I disabled stp on the access switch (Y...
I have 2 routers I am trying to connect through Wirless link (7609-FO-copper-Wirless-copper-2651XM) the interfaces in both sides are up/up but they can't "see" each other through cdp nor route packets. the obvious suspect was the wirles link (pair of...
The en of the matter:RIAMA_003_CCCN(config-if)#spanning-tree portfast edge%Warning: portfast should only be enabled on ports connected to a singlehost. Connecting hubs, concentrators, switches, bridges, etc... to thisinterface when portfast is enable...
Thank You for Your reply:Cisco is running pvst, so for some vlans the 6500 is the root for other is not, for that particular vlan the root comes "upstream" from a core switch (with the lowest priority in the network).There is, apparently, a small phy...
Yeah, I found that odd too. omg I'll have to talk to the main office, they kind of hate when I imply they are in any way wrong
I'll post any findings.