Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, My name is JUNYOUP KIM.
I Upgraded FireSIGHT (5.3.0.2 > 5.3.1), and Installed Patch(5.3.1 > 5.3.1.6)
OS Upgrade was completed(5.3.1), but Patch not Installed. > Fail
Fail Log --> Appliance Sourcefire3D is already being upgraded to 264, start...
I am not sure what your SIEM solution is, but in the case of Splunk or Arcsight, threat events, packet data, connection events, etc., are transmitted via eStreamer. All other logs are only available through Syslog. Configure the Syslog server under P...
If you replace the SSD, all settings will be reset. Therefore, disable HA first, replace the SSD, set up the image, and synchronize with FMC. After completing the basic settings, re-enable HA.
If you do not release your license from FDM, it will show as registered with FDM in the Smart Licensing Portal.Therefore, first remove Smart Licensing from FDM and register FMC through Configure manager.Then, go to the FMC > License > Smart License m...
Hello, I too am experiencing the same problem. I upgraded from 7.0.5 > 7.2.9 and the Connection Event does not appear after that.When an intrusion block occurs, a Connection Event should be automatically created, but it is not being created. Did you ...
