Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
We have a weird problem on a Cisco ISR4351 when configuring a numbered access-list using object-groups for source and destination hosts.
We do not run into any problems when configuring the access-list, and the configuration appears in the r...
Hi Guys,
We recently upgraded our ASA to 9.5.2 to allow us to have a separate routing table for the management interface, and allow us to reach the TACACS server through this interface. We currently have ACS for TACACS.
After upgrade, we are no long...
Hi,
Named access-list instead of numbered worked fine. After performing the reload, the access-list was applied normally. Please note that this has also been tried on another router (4321) with the same results as previous ones, but with different IO...
Hi,
It actually marks the access-list using the object-group as invalid. The object-group remains in the configuration, but the access-list is not present in the running-config. It is, however, present in the startup config, but applying it during s...
Hi Julio, thanks for your input.
I did a thorough check on Cisco's bug tool, and I also upgraded the software on the router to 3.16.5S(ED), which appears to be the latest recommended version, but the problem persists.
I also checked the release notes...
