Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Is it possible to mimic classic transparent FW bridging between two vlans in same bridge-group, by using the same BD which is also the GW and stick each FW leg into EPGs using flooding in encapsulation or is it better to place the FW legs in di...
Hi experts,
I can see traffic from EPGs with L3 BDs on a Tenant SPAN however not from L2 BD based EPGs and I'm using Gen1 switches. Is it a limitation on Gen1?
Thanks
Hi, I have a test VMM domain setup where I can't ping the gateway from any VM attached to an EPG tied to a VMware VMM domain. Both the vpc leafs pair and the ESXi hosts (UCS-B) can see the FIs via CDP:
Leaf201# show cdp neighbors | begin UCS
UCS-6120...
Hello experts,
I would like please to validate an information in regards to the new feature in 2.0 "EPG Deployment through AEP" my understating is it's meant to facilitate the EPG to EP mapping by directly attaching the EPG to the AEP via vlan tag in...
Hello experts,
Could you please confirm if the FEX HIF ports can be used on L3out ? I couldn't see any HIF port on the L3out interface profile static path it only shows the native leaf ports while they're visible in a regular App EPG as a static path...
creating a vDS in APIC is not disruptive however moving the VMs NICs from their actual port-group to the ACI managed vDS will obviously be a downtime. Also keep in mind that ACI must the IP GW for these BDs
Hello,You have 3 options:- Buy minimum ACI fabric: 1 APIC server, 1 leaf, 1 SPINE or whatever is your case.- Use ACI simulator which simulates an ACI fabric with APICs, it is useful to get familiar with the UI, test the APIs or integrations like VMM ...
Leon,
The user tenant L3Out is a static route so even by exporting as provider a contract to common shared L3out or using a contract living in common the route does not appear in common:default vrf table. The User L3out is set as shared as well.
Thanks Jason,
I notice that you can't mix EPG via AEP method with static paths you have to:
-Deploy the EPGs from the AEP by choosing an encap (the vlan doesn't even need a pool or domain) as tagged =works for trunks only.
-Create 1 Interface Policy ...
