Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am deploying a new ACI fabric. We are using Nexus 9364C-GX as spine switches. I am unable to discover anything past the first leaf (which the apics are connected to) because the 9364C-GX can operate as both leaf and spine and by default it is opera...
Dear all,I just wanted to know what your thoughts are on the following issue that I have. I have an internal Router that receives various subnets of the 10.0.0.0/8 from internal core routers via an IGP. I have an IPBGP peering with a WAN router which...
I am using callmanger express 7.0 and am attempting to enable MOH.I have a combination of 7961, 7940, 7960 handsets. I have used the following configuration:1. telephony-service 2. moh music-on-hold.au 3. multicast moh 239.10.16.4 port 21234. exit 5....
Hi,I have a Cisco PIX 515E router with an unrestricted license. My internal users can access the internet via the leased line router connected to the outside interface. The DMZ users currently get out to the internet the same way. However, I have bee...
Hi,I'm trying to upgrade a 3750 stack with three switches. One of the members has afile called "lslss". Do you know what it is used for ?. If it remains, I will not haveenough space to load the advanced ip image.Directory of flash2:/ 2 -rwx ...
Hi Sergiu,It worked as we discussed. I temporarily patched the leaf's that have the apics to the fabric ports (63-64) on the spine. The Nexus 9364C-GX were then discovered by the APICS. I then registered them as spines and they rebooted as spines. On...
Hi Sergiu,Good question. I will go back to site this coming week so I will try it and let you know. I may just move the ports connected to theLeaf switches that have the APICS attached to see what happens. Once the switch changes to a spine, the othe...
On the Nexus 9364C which is fixed as spine only, you can use any ports as you cannot change the mode. It would be a shame if I have to use the ports from highest to lowest just to get the Nexus 9364C-GX to work as a spine switch
Hi Sergiu, Many thanks for your reply. I am using aci-n9000-dk9.15.1.3e.bin. My issue may be because I am using ports 1-16 from the Nexus 9364C-GX and not the required ports below. Spine discovery via leaf – Connect a discovered leaf to one of the d...
Hi Jon, I am just happy that you have taken time out to assist. Thank you so much and I will check and let you know when I have figured out the cause. Take care
