About jrockett1

jrockett1 · 10-14-2010

Greetings. I have a WAP4410N new out of the box will not stay powered on any of our three 3550 24 port PoE switches running 12.2(25) ipservicesk9-M EMI. The WAP4410N is running the 2.0.3.3 firmware. Unfortunately the AP is the only PoE device I have ...

jrockett1 · 10-19-2010

Well that stinks. Thanks for the info, I'll store this away for future use. At least I can power it up via the adapter then remove said adapter to use the PoE function if needed. Funny thing is I had already sent it back to Cisco to be replaced.

jrockett1 · 10-15-2010

Today I was able to keep the AP powered on the switch with only the eth cable by powering the AP with the power adapter. After the power light was solid I disconnected the power adapter and the device continues to pull power from the switch. Could it...

jrockett1 · 10-15-2010

Below is the debug ilpower event output when I plug the AP into the switch. Thanks.1d02h: ILP uses Link Disconnect(Fa0/22): state= ILP_LINK_UP_S, event= PHY_LINK_DOWN_EV3550-24-Ins1#1d02h: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0...

jrockett1 · 10-14-2010

I plugged the AP in with the power cable and connected it to the same port (fa0/22) on the 3550. The AP remains powered and the PoE light on the AP is solid green and I am able to access the web gui for the AP. A "sh power inline" displays the below ...

Member Since	‎06-09-2009 03:40 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5

User Statistics

User Activity

WAP4410N will not stay powered on a 3550 PoE

Re: WAP4410N will not stay powered on a 3550 PoE

Re: WAP4410N will not stay powered on a 3550 PoE

Re: WAP4410N will not stay powered on a 3550 PoE

Re: WAP4410N will not stay powered on a 3550 PoE