Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Put the gateway in a "Location" that has enough CallManager allocated bandwidth to support only the number of calls you whish to use on that PRI. Use AAR to reroute the calls to the other (remote site’s) PRI when the bandwidth maximum is reached.I a...
CSIM is a router command. If you are using MGCP the operation of the voice ports is controlled by CallManager (the call agent) and not the router, so CSIM will not work with MGCP gateways.
Go to the Route List first. Find the Route Group under the Route List and open it. There you will find a prefix number parameter for the called number.
Hello Olivier,You can also extract SNMP information as shown in WIN 2000 Performance Monitor. See http://snmpboy.msft.net/pub/perfmib/ for the dll’s. This is not a Cisco approved solution and I have not used it for alerts just extracting data.A thi...
