About alexdg

alexdg · 05-23-2002

Hi,I have loaded a new IOS on my 2501 and it seems that i can no longer run a break sequence to try to fix it.What can i do?Here is the output of my version:Cisco Internetwork Operating System SoftwareIOS (tm) 3000 Software (IGS-I-L), Version 11.1(4)...

alexdg · 12-01-2004

What the?Please clarify.If you do what you have desribed then packets will be load balanced over each default route.

alexdg · 05-26-2002

Well, thats what i have been doing! From within 60 secs of power up. It never works.Once i have sourced a new flash, what do i do with the old flash? Is there a way to delete its contents?I'll try the waiting game solution while i await some response...

alexdg · 04-25-2002

Did you set lmi type?

alexdg · 04-25-2002

Interesting.Why not tell them to stop monitoring for a little while so you can get in?Otherwise just powercycle the router and unplug the ISP :)

alexdg · 04-25-2002

It just depends really on your network design.Dont take it all as the bible.The distribution layer can do a lot of security and filtering but the access layer can make the dist layer do less work by adding a bit more of security and filtering.

Member Since	‎11-04-2001 09:18 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	13

User Statistics

User Activity

Loaded new image but router no longer boots.

Re: Two default routes?

Re: Loaded new image but router no longer boots.

Re: Error message: Line protocol is down.

Re: Console port cannot log into Router!!!!

Re: Distribution layer, access layer