Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On the SRP 527W, ethernet 4 is labeled as LAN/WAN, but I can't find how to configure it as a WAN port. The 'VLAN settings Add Entry' help suggests that I should be able to give a VLAN a WAN 'role':"RoleTo select the radio button WAN, you sould add th...
Using 1841 with 2x HWIC-1ADSL-M, different ISP on each for resilience. Not attempting outbound load balancing at this point. Default route is out of Dialer0. The problem is that if the Dialer2 drops, the router never tries to bring it back up again [...
Is it possible to use more than one hub with a DMVPN WAN design for the purposes of resilience? Failing that, can two IP addresses for the hub be specified on each spoke?This is only a small network comprised of about 10 spokes with ADSL and a hub w...
Does anyone know if policy based routing will be supported in the near future on the ASA. I have a client with two isp's and we have them setup for backup. However they really want to be able to use both lines actively but creating route maps for say...
Hi I am hoping someone can help with these couple of questions. If I had an 1841 with a dsl card in connecting to the internet say with a public IP of 85.158.64.1 /29 and I wanted to have a DMZ for a server that requires and address of 85.158.64.2 /2...
If I understand you correctly, the question you're asking boils down to "how do I use my WRVS4400N as an access point?" For most low-end wireless routers, the answer is, disable the DHCP server on the wireless router and connect the wireless router t...
What's odd is that if I clear the counters on ATM0/1/0 they never increment in either direction:#show int atm0/1/0ATM0/1/0 is up, line protocol is up Hardware is HWIC-DSLSAR (with Alcatel ADSL Module) MTU 4470 bytes, sub MTU 4470, BW 448 Kbit/sec, ...
I set a static route out of Dialer2 for a host, then put an 'ip sla ...' on it, so I know there is always interesting traffic for Dialer2. I have also forwarded syslog to a server out of Dialer0. I can see that at one point the SLA target stopped res...
