Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to authenticate to multiple (Radius, SDI) authentication servers on a vpn3005 concentrator, but I can't get it working. The server that is on top of the list Configuration - System - Servers -Authentication is selected others are ignored....
We have configured a lan-to-lan tunnel between a vpn 3005 concentrator and a 836 router. The tunnel works fine, except for the fact that the tunnel drops after several days. A router reload is neccessary to get the tunnel back up again. In the smnp l...
Hi,Is there anyone who can help me? I have a problem connecting with a vpn client 4.0.3 to a 3005 concentrator. Every time I try to connect the client stops with the: Remote peer no longer responding message. When I look in the event log of the conce...
When I try to connect to the concentrator with any software client, the cleint gets disconnected. When I use the 4.0.3. client the log shows the following output:433 09:46:27.657 12/23/03 Sev=Info/6 IPSEC/0x6370001FTCP SYN sent to xxx.xxx.xxx.xx...
The concentrator is configured to use MD5. De client should have no problem accepting this. The error you pasted in your message occurs several times when trying to connect. Every time there are other values. See below the result of 1 connection atte...
The cause of this problem was that the certificate transmission was not correct in the SA. The right setting should be: Entire Certificate Chain. After changing this setting the "remote peer no longer responding" dit not show up again.
It seems that this has to do with the user authentication: if I set the Authentication field in the Ipsec tab to None, the client authenticates (without the need to fill in a user/pwd), if I put it back to Internal, The client gets a "Remote peer no ...
It seems that this has to do with the user authentication: if I set the Authentication field in the Ipsec tab to None, the client authenticates (without the need to fill in a user/pwd), if I put it back to Internal, The client gets a "Remote peer no ...
Hi Jarle,We use ACE Server from RSA Security in combination with CS ACS 2.4. We use SecurID hardware tokens. The AAA mechanism is primarily handled bij ACS which sends the request through to ACE Server to verify the token-code. We are using this for ...
