Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Guys I have the FMC Virtual Appliance in version 6.2.3 and the FTD in version 6.2.2 an ASA 5506-X with FTD image installed. Whenever I try to do deply in FMC I get this error message: When I click on details, I have identified that there is a ro...
Hi, Guys I have the FMC Virtual Appliance in version 6.2.3 and the FTD in version 6.2.2 an ASA 5506-X with FTD image installed. Whenever I try to do deply in FMC I get this error message: When I click on details, I have identified that there is a ro...
Hi, Guys
My question is whether the Nexus 9300 series switches model supports TRILL. I am participating in a deployment of a DC with Spiter Leaf architecture, where HP will work as leaf and the spine will be a Nexus N9k-c93180yc-fx. I'm not sure if...
Hello Guys!
Recently I came across a problem that a custumer is complaining that when you establishes the VPN calls are poor, like shredding and fizzle, but within the internal network calls are normal.
I started a series of procedure to enable t...
Hello, Guys..
I have a doubt regarding a scenario that I built in the Unet Lab.
The image I have 2 Sites in a company: the LAN site 1 is 192.168.0.0/24 and the LAN 2 site is 192.168.0.0/16. I can successfully establish a VPN between the two site...
Hi.
I imagine that you did not understand: the site1 LAN 192.168.0.0/24 's and the site's 2 LAN 192.168.0.0/16. These two NAT rules that you asked to remove, are the rules to solve the problem of the overlaps of the two sites for them to communicate...
Hello my friend.
Unfortunately the configuration you gave me didn't work. After the tests, can't do ping test for the 2 SITE through the VPN. Note that in the debug when I try to ping test to a SITE host 2 or to the internet, it give match IPSEC NAT...
Hello Krash
Sorry for the delay. Yes I can ping both the 10.83.0.11 as the ip 172.1.0.75 ip. However ping works only for ip 172.1.0.75 before I configure NAT; After configuring the NAT ip 10.83.0.11 's answer and the 172.1.0.75 IP no longer responds
