Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I would like to automate the backup of the configurations of our catalyst 6509.Does anyone know a way to do this, using the snmpset command for example?I don't have CW2000...Thanks a lot for your help.
Hi,I have a dedundant Internet access (with two different ISPs): two leased lines endind up on two different Cisco routers (both running HSRP for redundancy and BGP for routing).Problem: the line from ISP1 is full while the line from ISP2 is almost e...
Thanks for your help, but....I already checked these links, but it's not very clear for the catalyst 6509...in fact, if I use the snmpset command with the following OID: .1.3.6.1.4.1.9.2.1.55.xx.xx.xx.xx (xx.xx.xx.xx being the IP address of the TFTP ...
Hi,thanks for your answer.No, I have only 2 routers:The ISP1 leased line is connected on R1, and the ISP2 line is connected on R2.My concern is the routing from inside to outside (I have no problem with the other way).Due to the routes learned by BGP...
