Hi i am looking how i can keep backup from FTD when i have only ssh access,for example on a switch i do show run and i have almost all the infos to restore the switch but with the firepower i am not sure if its possible. In this case we dont use FMC...
Hi i use a Firepower to filter the traffic , so from the wan router is going the traffic to the switch with vlan 10 and then a portchannel with switchport access vlan 10 to the firepower and a second portchannel which send the traffic from Firepower ...
Hi all, i am new with ftd and fmc and also new in the Firewall i dont have any experience thats the reason that i need your help from lan side i have a trunk port with allowed vlan 10,11 and i use portchannelthe ftd will be transparent , how i can co...
Hi all, i have on FMC the snmp configuration i add all the info like read community listen port 161 trap port 162 and the hosts, everything is ok we see all the traps but i dont see any interface on our monitoring tool, have someone an idea? the FTDs...
Hi all, i want to update a 3850stack without to have an downtime, is there any solution? Because so far i know if i reboot first the primary then we have a firmware mismatch. Thanks a lot.
just a question, there is the possibility to copy the backup on an ftp server and not only on the hard disk on the FTD? in case that the hard disk failed.
i have two firepowers and two switches but take the example 1:1 one Firepower connected with one switch with two port channels, the one is access vlan 10 and the orther 20 , the Firepower is transparent mode and i saw in the switch log msgs mismatch ...
traffic is going like this from Core switchport access vlan 10 ---> Firepower ports only enable not trunk --> to core switchport access vlan 20 and i am almost sure thats the reason for the vlan mismatch... with a catalyst i just saw the mismatch but...
