Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured 2 WAN Edge routers as a dual router site, each has a dedicated WAN circuit. R1 has public-internet and R2 has biz-internet. I have also configured a tloc extension between the two so that R1 can use R2 biz-internet transport and R2 ...
Hi Guys
What I'm trying to achieve:
1. Every time an engineer runs the write-memory command, a copy of the running config is sent to my SCP server.
2. Every 7 days, a copy of the running config is sent to my SCP server.
3. The password in confi...
Calling all OTV experts
I have configured Multihomed OTV in a virtual lab on EVE-NG using Cisco CSR's. The lab is 2 x CSR at one site both connected to layer2 'customer' switch and a single CSR at a remote site.
Everything works good apart from on...
HiI have the following EEM Policy that I thought would remove itself then perform a 'write mem' but the policy seems to terminate at the point it removes itself from running config without the final 'write mem', I am running the below EEM version whi...
Needed to configure an 881G with a Vodafone 3G SIM in for an urgent job where the customers WAN circuit had failed- Tried 3 Vodafone SIMS, 2 x PAYG and 1 Contract. all of which worked fine for data in the phone.- Followed the Cisco recommended settin...
Hi Jeongjun
Thanks for taking the time to reply.
I worked out what the issue was, I had forgotten to bond the WAN interface to the TLOC extension interface on both routers. Once I fixed that each router was able to create control, IPSEC and BFD conne...