Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning Community,I am having a problem setting up VLAN's on my home network. Here is the scenario:My ISP router is in transparent mode.I have an 1841 running in PPPoE mode and the public address is dynamic.I have verified that the IV Routing is...
Hello, I have configured a router to run PPPoE with a DSL router in transparent mode. Here is a brief description of the topology: DSL Router (Transparent mode)-> Cisco 1841 router running PPPoE-> Cisco 2950 switch (base config)-> PC The router is ru...
Does anyone know how to set up IP redirect to an address not in your LAN- through the web without using a RADIUS server? I am testing ways to deploy a hotspot that will direct users to a predifined page once they access the WLAN. Any help would be he...
Thank you!!! I was able to get the IV-routing working after the configs of the internal interface were taken off. I also removed the firewall settings. I am not sure what was blocking traffic in that configuration. I configured the FW with SDM, so I ...
With the attached configs for the 1841 router, I can ping outside addresses when I am on the router. I can also ping the default gateways of the vlans and the laptop connected to the switch. I did not submit the switch configs because the inter-vlan ...
Sorry for the long delay.I configured the router and switch with the sub-interfaces and vlans as we discussed. I was able to ping everything on the network- default gateways of all vlans, my default gateway and the internal interface of the router.I ...
I am alright with the subinterfaces. Everything will be static addresses except for wireless and I will create a pool on the AP. Do I really need pools on the router if I am statically addressing?
