Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Need some guidance here.
I'm having Cisco WSA S690 on 10.1.1-235. It is having Decryption enabled.
Issue is that any Finance category website is to bypass decryption but still WSA sends it for decryption and blocks the URL. It does categoriz...
Hi,Since few days I'm facing issue of low signal strength and frequent disconnections of WLAN for many of my user's. In my organization we are using AP1230AG in autonomus mode and some with WLC.I have checked and we have configured power at max in Do...
Hi,Since past few days I'm facing issue of rouge DHCP broadcast in my company network so I planned to deploy DHCP Snooping on my LAN environment. For this I implemented DHCP snooping on one switch on test basis to see the result. Below are the comman...
Hi,I'm curious to know what is Supervisior Engine or Supervisior Module that is used in 4500 or such higher modular switches. And how to configure them. Also how to check the current configuration of any switch having sup installed on it.I'm having a...
Hi,In my current setup I'm using PIX 525 which now i want to migrate to ASA 5520 replacing PIX. I was wondering and curious to know if I can use PixtoAsa software for the same.I request help and guidenss for any once aware about.TIAAshish Shah
Hi,Thanks it is working for me.I will be deploying this in one of Production switch and observe.I have one more query as in what command statement " ip dhcp snooping limit rate 202 " stands for?ThanksAshish
Hi,Thanks for your input.I'm trying to use and configure below command and do proof of concept before final roll-out. I will revert back if any help required for the same.Thanks!Ashish
