Hello,I am struggling with this, I have a scenario were I need to redistribute (selective) static routes into Named EIGRP. Because the nature of needing to be selective I am using a route-map which identifies the routes with a prefix list (also trie...
Hello,I have a Cisco ASR 1006-X that I cant seem to get the crit led light to go off, I have been under the impression that interfaces that are down, down vs being admin down would cause this but all my interfaces are up, up or admin down.I have atta...
I had this same exact issue, I had my multicast working in a non-dmvpn LAB but after moving into a production network with DMVPN it was not working. For me the fix was adding the following on the DMVPN Hub Router.ip pim nbma-modeI guess the other bi...
I figured this out, this was a GNS3 lab, so my next hop address on the static route was not up as this was a rough test....I reached out to a old college, and explained how all seems good with the config and I keep coming back to the EIGRP basics, fo...
Okay I wanted to update this in the event anyone else runs into this, following the recommended procedure from cisco resolved the issue.I did a On Line Removal of each fan module one at a time and the Crit light is now off, thanks for everyone's effo...
Here is where I am with cisco support currently, I will test the resolution outlined in the bug. I figured I would share just incase any others find this beneficialHope you’re doing great. Upon further research and discussion with our colleagues, ba...
