Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running an Oracle RAC database 2 node cluster on Cisco B200M4 / Firmware 3.2(3i)B / enic 2.3.0.53 / and see RX drops for one VNIC interface. We then have increased RX/TX queues, ring sizes and RSS in Ethernet Policy and will enable MTU 9000 t...
Dear Community,We are trying to set a up a Cisco UCS Blade System for SAN Boot. The SAN are two EMC VNX 5300 Storages and the OS is OEL 5 Update 8 x86-64.Steps performed:-> boot lun with 300 GB configured on both EMC Storages and granted access for...
Hi Kirk,thank you for your reply."-p" is for port. Yes, i have of course set a specific port."-w" is for window size/socket buffer size. No, I did not specify "-w".However, we have specified these kernel parameters:net.core.rmem_default=4194304net.co...
We have decided to stay with local boot disks and avoid SAN Boot as for now. We have already lost too much time here and I am afraid that the system will not be as robust as needed.The local hard disks are RAID1 with hardware RAID. Can we move the tw...
Padma,thank you for your response.A: We are using RH compatible kernel, not UEK.A: Yes, we have multipath enabled.A: Yes, we are planning to use LVM on top of Software RAID (mdadm).A: We have 2 independent storages in two data center rooms. We have t...
