Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,I'm not sure how to setup trunked vlans from an 881 running 15.0 back to another 881 at main office. I have two 881s running in a test setup over a DSL link, test users off branch 881 can reach our main office over an IPSec tunnel and g...
Thanks for this Stephen.I have changed these timers over the years trying to work around client problems.Can I verify the defaults/best setting these should be?(Cisco Controller) >show advanced eapEAP-Identity-Request Timeout (seconds)........... 60 ...
Hi,>lemme know how this answered your questionyes and thanks.Just a note, when I set the Radio Policy to 802.11a/g only (just to verify, this still lets n clients work OK) I did loose Client Band Select.This still shows enabled/checked under WCS and ...
Running 7.0.98 Can set WLAN Radio Policy to 802.11a/g only for the SSID 802.11b clients can not connect. The 802.11b/g/n Network Data Rates do not change.Did this two weeks ago and all seems good, no more 802.11b clients.Question: Is this the curre...
Thanks Giuseppe!I did get the L2TPv3 up and running over two 7206 routers and could pass my tagged VLANs OK but they took a hit on CPU usage. I never was able to get tagged VLANs running over the 881s, OK on untagged, it may have just been me not kno...
Greetings,To beat this dead horse some more! Running 7.0.98, on WLCs and 500+ 1142 access pointsIf set WLAN Radio Policy to 802.11a/g only My 802.11b clients can not connect. ( good ) The 802.11b/g/n Network Data Rates do not change. ( good I believe...
