Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi experts,
I have a Cisco 800 series ADSL modem router that has been running for the past 5 years with no issues. There has been no configuration changes, but recently there has been a few power outages and for some reason any PC connected directly...
Hi Experts,I have a strange issue where the first ping always times out, but the following goes through fine.I have Cisco877 and connection to the internet is fine. I connect a PC to one of the FastEther ports and I am able to ping the router without...
Dear Experts,I have a Cisco 877-SEC-K9 router and I have setup VPN access on this device. I am able to connect to the VPN but I can't ping any of the devices behind the 877 router. THe only thing I can ping is the gateway. However, the reply source t...
Thank you to everyone who has had input. This is the config i have on the cisco 877. I am able to ping from the device itself without any issues, but from a PC attached to the ether port the first ping always fails. If i do the ping a second time to ...
FastEthernet0 is up, line protocol is up Hardware is Fast Ethernet, address is b4a4.xxxx.xxxx(bia b4a4.zzzz.zzzz) MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback no...
Thanks for the replies.I have an external dns address configured and works. I also extended the ping from my windows machine to 10 seconds and still the same outcome. I also ping the ip address so it isn't using the dns to resolve the name and sti...
