Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking at T1 WAN link bandwidth usage reports, what are the criteria for time to increase bandwidth? When can I justify to the boss that it is time to add another T1?
I am trying to reset a lost password on an old 2509 router. I have entered the break key sequence at boot and the router load sequence stops with a '>' prompt not a 'rommon>' prompt. It does not accept the command 'confreg 0x2142'. Entering a '?' com...
MS KB article # 158623 speaks to 5 static port numbers: 389,522,1503,1720, and 1731. And two dynamic port settings. How do I configure my PIX to pickup these dynamic ports?
There is a discussion going on concerning how many servers are best for a certain scenario and I wanted to get the collective wisdom of this group. This is the scenario: XYZ Engineering company has a regional HQ office that is home to approximately 1...
I have been asked to get some network utilization numbers. I have a copy of Etherpeek network analyzer, to quote their manual: "Typically, switch vendors offer a monitoring port as standard issue on their devices to allow a network or protocol analyz...
That's a lot to consider. I just got back in town from a vacation please excuse the delayed response. I will order this book today thanks much for the tip. Thanks again for the suggestions. I will start working on that ASAP. I hope you won't mind if ...
Thanks for the response. I am seeing above 50% for hours at a time several days out of the month and peaks above 60% on these days for several minutes at a time. The primary apps are CAD and MS Office with a smattering of html based apps like timeshe...
Thanks for the response. Yeah that is kind of a weasel word answere but I understand. It's like everything else we do, the answer is almost certainly, "It depends". The link is regional but I am getting no metro discounts on rates. The primary apps a...
Thank you for your response. This is what I have in the PIX config now:access-list acl-out permit tcp any host 123.123.123.123 eq h323access-list acl-out permit tcp any host 123.123.123.123 eq ldap access-list acl-out permit tcp any host 123.168.123....
