Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a Cisco 1841 router connected to the ISP and I have the LAN side of the router connected to an ASA5510. The ASA5510 is in turn connected to a catalyst switch with 6 VLANs configured on it. The ASA5510 has subinterfaces which are connected to...
Hi I have a 1721 router with two interfaces One 1ENET and a DB60 serial interface to two different service providers with two different Ip addresses. I also have a single fa0 interface which connects to the LAN. I need this LAN to NAT and connect t...
Hi I desperately need help. I am trying to configure 2 Aironet 1310s as Root bridge and non-Root bridge. When I configure the root bridge the wireless interface remains up.When I try to configure the non-root bridge the AP/Bridge will assume the role...
HiI finally made a breakthrough. The issue here is the internal antannae. It seems it does not work well. I tried to use the antannae from the linksys wireless router and enabled them, I one time got the radios associate. I connected to the network a...
HiDo you have to set the channels on the same frequency for the root bridge and non-root bridge like any other radio??? This one seem to change the channel automatically even when you set one manually.
