Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We run a hub and spoke IPSEC VPN setup for a client. We run GRE inside the IPSEC in order to pass OSPF. Tunnels work very well, including RDP, etc., but will not pass an H.323 voice session. VPN is router-to-router, 1711 on one end, 2611 on...
I am trying to modify and existing Dialer watch setup to only initiate the backup dial-up call during certain times of the day. I have used time-base access lists in the dialer watch-list, but it doesn't seem to work. Dialing occurs at all times......
I have SSH sessions to a 2611 fitted with a NM-16A serial board. These sessions fail inexplicably after 2-4 hours. Telnet sessions are immune, pings show less that 1 pct. errors. Any ideas? Can you tune the SSH parameters to be more robust?Bruce...
Hello,I tried a password recovery on a 515(r) running 6.3 recently without success. I was never able to get a successful ping to the attached host. Commands all seemed to work, but no communication, apparently. Any ideas? The PIX has 3 interfaces...
Hi Vincent,You're right...but I am using Dialer Watch because I don't have much choice in the application. I guess I'll just have to wait for the feature to be added...Thanks
Hi Nilesh,I will try, but the remote router is a production box in a remote location, and I *don't* want to have to drive out to reload the box. The entire router config is below.My experience is that the dialer watch doesn't appear to hit the acces...
hi, I didn't see a "route outside 0.0.0.0 0.0.0.0 x.x.x.x" statement in your config. Could that be the problem? x.x.x.x is the address of your default destination, presumably your outside router's IP address.Bruce MacDougall
