Hi,  After a power failure my As5300 start to give this error messagerommon 2 > boot flash:c5300-js-mz.123-18.binloadprog: error - Invalid image for platforme_machine = 35, cpu_type = 59 boot: cannot load "flash:c5300-js-mz.123-18.bin"orrommon 3 > bo...

HI,  I want to known if there is a command like calling-number outbound for E1's with R2-Digital ?I use the reverse telnet at 7001 port to dial to a provider and I need that on the providerappears 30 different numbers instead only one (E1's trunk one...

Hi, I have an AS5300 with 8 E1's and r2-digital. I use it to dial-out with telnet. But all calls always apper to come from the caller-id t, one of the main 8 trunk numbers of the E1's. There is a way to set the extension number for each modem for ex...

Hi, I use an AS5300 with 240 mica modems and sometimes when I need to turn off the power after I turn it on again not all the modems seems to start correctly. Most of them fail in the C state when I am dialing out. And surprisedly they start to w...

Hi, I tried to setup a dialer to be activated by any traffic but it doesn't work. I tried to generate traffic with ping command.Bellow is the dialer configuration:interface Dialer1ip address negotiatedencapsulation pppdialer pool 10dialer idle-time...