Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a customer with cisco router has dual WAN and single LAN, customer required that dual WAN should work active/activeI changed the IP but the config is copy pasted, from below config the connection still going through ISP1 only, what should I ch...
before I post this I have checked the community for similar request, but I couldn't find something working for my situation.
I have 2 sites one of them has 1 router facing 2 ISP, I need to make them active/active for 2 LAN networks splitting them usi...
I have an issue on Cisco switch 3750x ( 15.0(2)SE2 C3750E-IPBASEK9-M)suddenly current existing network has its DHCP pool all addresses excluded, created multiple new DHCP pool to test but same result ( screenshots).Cleared DHCP binding and cache but ...
my post marked as spam i dont know whyi am doing a lab with packet tracer and i cant reach inside network to dmz asa config hostname ciscoasanames!interface GigabitEthernet1/1nameif dmzsecurity-level 50ip address 172.19.3.1 255.255.255.252!interface...
running cisco ASA 5516-x with DHCP relay enabled some of PC are getting IPs and others not, i have tried alot of TS steps here are some of DHCP relay debug from the ASA ( i want to know if the ASA dropping something or is it DHCP server issue ?)dhcpr...
Thank you for the link but in my case the customer LAN is just one subnet needed to be shared with dual WAN no servers no special ports for specific wan just 10.60.31.0/24 this subnet for both WAN, how do I achieve that and what is the right natting
thank you for your helpfrom your approach i realized that i was tracking 2 default route and only the 1 default i had to track and the fall over with higher metric will takeover in case of the other one fail.but my question is what if the ISP router ...
ok then from real world senario when i implement this, what should i do ? another thing when i add default route with track at the end last resort default gateway disappear and i lose connectivity from PC to r2
