Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear friendsi want to know the exact meaning of this command "pinning max-links 1" in a scenario. consider we want to configure port-channel and there is 4 link between nexus 5000 and nexus 2000. what is the diffrentce of configure "pinning max-links...
hIi have one cisco MDS9222i with factory default configuration. i want to connect HP EVA6100 and HP MSL6030 Fibre channel drive to MDS9222i. also my management server is connected to MDS.MDS9222i ports are enable and up and detect as F port on connec...
Hiwe have 2 WS-4507R-E chassis. these modules are installed on each chassis:module 3:WS-X4516-10GEmodule 2: WS-X4418-GBboth chassis has same IOS:cat4500-entservices-mz.122-52.SG.binProblem is: on one of the WS-4507R-E chassis when you install WS-X441...
i tryed to ask my question in scenario:please consider two seprate switch:SW1 and SW2.we create VSAN2 and define "zone a" and "zone b" on SW1 and we createVSAN3 and define "zone c" and "zone a" on SW2Now, we connect via trunk link these two switches...
i have amazing problem. i tryed to nat one of my private ip address to one of my public ip address in fwsm. it worked fine. for example, nat 192.168.1.1 to 217.218.100.2. my 6500 switch is connected via one 3560 switch to internet and all of my LAN d...
Hifinall i received your requested log. customer said he test module on another slot but problem still consist. you can see on attachment about log reports
Hifor now best practice is not my issue. i want to solve my problem first. MDS 9222i switch is in factory default configuration.So, i didnt define any zone. all ports are in VSAN1 and all ports mode is FX and operation mode is F. also,all ports are e...
