Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been using the number2name tcl for a while with great success. I have recently tried to add more entries to the bulklist.txt file and whenever i go over approx 1200 entries the tcl fails. The error i get is:Nov 15 13:07:51.491: TCL script fail...
Hi,I have an issue with a 6500 trunk, this unit has a SUP720 and multiple 6148-GE-TX cards. The configuration is a simple one, and has a simple fix. I have VLAN 203 on two ports, one port simply has an end station on it and the other port has a 2851 ...
Hi, I have a strange problem on a pair of 6500's. The configuration is such that both units are connected together via a port channel dot1q trunk that allows all vlans. One of the switches is running the inter vlan routing with the gateway addresses...
Hi, I have a 6509 that will be used to power many non Cisco Phones. My concern are the power supplies in the unit. I based my calculations on the actual power draw of the phones (4.4W). The supplies are fine for this, my question is whether the 6509...
I have two Unity servers in standby (manual) failover and was wondering what the status of the units would be if the LAN connection between them failed. The scenario is that, i have two buildings each with thier own incoming telco connections and exc...
Please note important change the VLAN 203 has been changed to 103.The 6500 port in question is port gi1/18This is the output from the 6509 when the 2924 is in line:Port Mode Encapsulation Status Native vlanGi1/18 on 802.1q trunking 1Gi3/17 on 802.1q ...
Hi, Thanks for all of the replies, i cannot get access to the switch until Monday to obtain some of the info requested. The trunks are definately dot1q as i do not get the option to set encapsulation dot1q on the IOS for these interfaces. This is ac...
Ediortiz, Yes everything shows OK in both MAC and ARP tables on the 6500's. I think the forwarding and VLAN/ARP is all good because if i plug a phone into a static non trunked port in either the data or voice vlan it just works. The problem i have i...
Hi, Thanks for the response, i am on site and still failing to make any head way. Since the post i have now disabled the port channel and am just running a single dot1q trunk between the switches and i am still having the same problems. The routing ...
Hi, I had exactly the same problem. TAC investigated for weeks and found that it is caused by HTTP debugs running. Try tuning off all debug logs under "Logs -> Settings" Interestingly it was TAC that asked me to switch them on in an earlier case. I...
