Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Struggling to the answer find in cisco doc'swe're wishing to replace the hashed out values of the[support Information Page settings] in the [client provisioning portal] cant see them in the [portal page customization] we configure / attached / - ...
Hello Allusing ISE 2.2- client = anyconnect 4.6 getting ready to deploy posture checking :when testing - forcing failures / successes - we where using a restart of the cisco anyconnect secure mobility ISE posture agent - services, in order to repea...
2.2 Hi - we're deploying posturing - using the defaults : AM / filecheck / FW enabled etc.However, we wish to check for AV installation ( and further down the line its definition , last patched ..etc)HOWEVER, any creation of a posture requirement for...
ok ladies & gentlemen please stand down ...as we've managed to work it out ...Ironically we had tried this previously , however, not in the correct way ....due to restricted access of the testing client we couldn't copy the *iseposture*.xml off the...
Thanks Miketook a look where you suggested - however, the lowest interval on reassessment is 1hr in these setting ? This period for a failed compliant / rescan is obviously too long for usIn our senario - we wish to see if the client fails complianc...
Thanks for the rapid response I will try that / however, this i somewhat obscure in the GUI wouldnt you agree ?- as sophos isnt AM it's AV ..and we already have a AM check for Fireeye s/w ? So now we'll have 2x AM checks - NP's however, whats the iss...
