Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What experience does the group have with roaming under LEAP?What type of delay do you see when roaming between APs in an office, warehouse, or manufacturing environment.I would expect that the windows clients would and could do this pretty seemlessly...
Hi all,In warehouse or manufacturing environments where there are a loarge number of clients and a large number of APs (350s in our case), the 350 seems to wait until the quality of its association is really lousy before it tries to roam to another A...
Hi all,In warehouse or manufacturing environments where there are a loarge number of clients and a large number of APs (350s in our case), the 350 seems to wait until the quality of its association is really lousy before it tries to roam to another A...
Try setting your radio preamble to Long on the AP in the Advanced Radio Hardware settings page. This is needed when 4800 clients associate with 350 APs and may help you.
Thanks for your reply!I assume that you meant RTS retries and data retries. There is no setting for CTS. Are you reommending a change to the RTS threshold? If so, why?Thanks again for your help.Brent
Thanks for your reply.Our APs have the latest software and radio firmware package (11.08T). Our clients, are a only couple of versions behind on both radio firmware and WinCE driver.Thanks,Brent
We are having similar difficulties with Telxon and other clients running 350 cards and 350 access points. In our case, our emulation is vt220 and telnet though. See my message about roaming. It seems that these clients just don't roam until their ...
You state that: if the signal levels drop too low or the bit error rate is too high, then it will begin scanning for another access point that has better readingsHow can you configure this? We have found that the client doesn't roam until his ass...
