Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I got a Faults event with Major Severity on UCS manager as below figure. And currently management plan is active on switch-B. I've tried to find some solutions with faults code, but no luck to find any solution yet. Anyone know where should I f...
ello, I got a Faults event with Major Severity on UCS manager as below figure. And currently management plan is active on switch-B. I've tried to find some solutions with faults code, but no luck to find any solution yet. Anyone know where should I f...
Hello,
I just got an issue of my Cisco switch C2960 Stack. I have configured two port-channel by each port-channel select 1 interface from switch one and another 1 interface from switch number two:
Ether-channel 3: G1/0/43, G2/0/43
Ether-channel 3: ...
Dear All,
I have a problem with my Cisco Switch C3650 stack after I added 3rd member into stack, but its role are different as below:
*1 Active 5c83.8f59.0580 15 V02 Ready 2 Standby 5c83.8f2d.4180 14 ...
Hello,
I have deployed FireSight about 4 or 5 months and it's working as normal. But I got a problem on 7AM 12-Aug (ICT +7) that all traffic have been blocked when go through SFR module. When I removed the sfr configuration the traffic is working as ...
Thanks Mark for your reply. Yes, it will help by recovery with --errdisable recovery cause channel-misconfig command.
But I'm not sure that it's a recommended solution or what? And will it impact anything? Because if I understand, this command will w...
Hello,
Actually, what I need as below:
*1 Active 5c83.8f59.0580 15 V02 Ready 2 Standby 5c83.8f2d.4180 14 V02 Ready 3 Standby 843d.c69c.a680 13 V03 Ready
Is it possible? But in stack switch standby role can have more than one switch or not? If not, I...
Hello,
I think I may confused or what that I need to change role on both switch 2 and 3 to standby role. In stack only one switch can be a standby role. Am I correct?
Regards,
Phaneath
