Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Might have a couple of faulty switchports on a stack of 3750 enhanced image switches. Have any of you run into something similar???Issue: 3 ports out of 48 are not relaying client DHCP requests. All the ports belong to the same VLAN 20 and have th...
I have read that the cisco recommended network diameter is 7 for STP. I was wondering if someone could further define this number for me? For example, if there is a set of 7 switches (3550 and 2950)linked together with gigastack uplinks and 2 fibre...
I have the following:1 x MPLS (Provider) router1 x Layer 3 3750 stack1 x ISDN routerBoth routers are connected to the stack and are in the same vlan. they are all running EIGRP 100.The MPLS router injects a gateway of last resort Gateway of last reso...
Here is the amended router config. I hope this is enough info.When EIGRP adverts stop from the telco router my ISDN dials, and I get the following. which shows the ISDN route in the routing table, but notice that when I do a traceroute everything is...
shall do, but a quick question. If EIGRP is routing everything through the other router and the static that get stuck has an admin of 240, what would be routed across the link and why?
watch your revision numbers on the access layer switches...all it takes is one of them to have the same or higher revision number and then you will have issues... even in client mode. At least that is what I have always been told...
