Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I configured remote access vpn such that remote users can access my LAN. I want some users to access an application server on my LAN.I can connect to vpn using cisco VPN client but I cannot ping any IP address in the internal network. The vpn clien s...
Dear all,I need help with configuring remote access vpn. I want some remote users that have internet access on their systems to connect to and access an application server in my corporate head office user cisco vpn client. I am using Cisco 881. I am ...
Hi All,Its good to be here again and I'll specially want to thank all contributors to this forum.Below is a sample configuration of my Router. I am trying to do QOS on the IPSEC VPN tunnel so that voice traffic can be given priority over other traffi...
Hi All,Its good to be here once again.I have set up VPN connection between my head office and a branch office. All the internal systems can ping each other and the phones (VOIP) are working accross the vpn.The only problem I have is with the Pastel E...
Hi All,Good day to you all. Its good to be back on line with you guys and thanks for all your inputs in my career as a network engineer.I wanted to block some social sites on my network and I added these entry to my config - class-map match-any socia...
Hello Abaji, Thank you for your prompt response.The VPN client is running on a window xp system. when i put off the firewall on the system on the local LAN, I can ping them from the remote system, though the ping is not very steady, time out rate is ...
Hello Andres,Thanks for your reply to my discussion. Your input was quite helpful.I was able to set up the vpn and it shows that it is up. But I cannot ping the internal systems/servers from the remote network over the vpn. Below is my running config...
Hello,I have a problem with configuring the vpn for remote users access. Can you help post the sample of your configuration that is working with your primary internet link?I really will appreciate your help.Thanks.Thomas
Hi John,I added "qos pre-classify" as you suggested but haven't noticed any change (improvement).Here is sho policy map int f1 output, as you can see I am still having 0 packets/0 bytes under SDM-Q0S-Policy-1 (I dont know how to interprete this anywa...
Hi Edison,Thank you for your contribution.Below is a rough sketch of my network. I have gone through the material you reffered me to. Please can you give me a sample config I can use for the network below. I want to configure afresh. But I have a pro...
