Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I have the classic requirement to extend the layer 2 vlan's to another data center via a 10Gb layer 2 metro Ethernet connection. I have the following requirements.
1- Extend the layer 2 VLAN's so no re-IP is required-- the two data ...
Hello everyone,
I'm in the planning phase of upgrading our Cisco UCS infrastructure and I would like to use the latest release that being 3.1(1E). I would like to know if anyone has had any issues with this release? Would anyone not recommend upgrad...
Hello Everyone!!I seem to be having a problem booting from SAN. Trying to configure a NetApp, Cisco UCS and VMware vPhere 5 setup. So I have the UCS system booting from SAN via ISCSI on fabric A. It boots just fine but it does post an error as you ca...
Hello everyone, I plan on deploying my first UCS system, very excited about this!!!I have purchase two Cisco UCS 6200 Fabric interconnect, 2 Cisco 5548UP with the routing card. I also have one 5100 series chassis with the new 8 10GB ports fabric exte...
Thank you for the assistance. Are the options and/or? Also if you would provide me with URL for the solutions that would be great!! Thanks again for your assistance!!!
The picture below shows my configuration. There is no internet connectivity in this solution. So my question is can I switch the layer 2 traffic through the ASR's thereby extending my layer 2 domain to each DC? Basically, behind each ASR I have serve...
