Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5500 with a RSM module installed. When I attempt to save the configuration on the RSM I receive the following error:[OK]private-config file open failed (File table overflow) I was able to write to the module a few minutes before I started ge...
Does anyone know if it is possible to setup a VPN 3030 or 3060 concentrator so that it communicates using IPX and IP. I do not see any options for IPX in the configuration screens. I have users that need to access Novell servers which are running IPX...
I am in the process of changing my VLAN management interface from the default of VLAN 1 to VLAN 2 and encountered the following:Current IP address of SC0 interface is an IP network that is not defined on my RSM. The IP network is configured on our 75...
We are in the process of installing a Websense server in our network and wanted to ask for opinions/recommendations on the location that would be best for installing a Websense server. Should it by on the inside of my firewall or in the DMZ? From wha...
I am in the process of changing my managment VLAN from VLAN 1 to VLAN 2. I made the change on a 5500 switch with a RSM module and it is connected to our backbone switch which is also a 5500 and it works fine. The problem I am having is how do you cha...
That is not exactly what I am looking for I do not want to put all of the Ethernet ports in VLAN 2 I only want to use VLAN 2 for management traffic. I plan on using other VLANs for user traffic.
The client works fine if it is going thru the PIX firewall but not when using the Check Point firewall. The person configuring the Check Point box says he setup the box to not block anything and it is still not working. I just found out that the Chec...
