Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Standalone 4404 - from what I'm reading with 5.1 and above (Document ID: 69561) I should be able to add more than 24 members to a mobility group. Has anyone had any luck with this - adding more than 24 members on a single controler?I upgraded to 6....
Has anyone figured out a way to get an AP set in Rogue Detector mode to stop alerting radio down/assoc/disassoc. The radio is down I understand but if you leave an AP in RD mode to monitor wired traffic you are going to get a flood of alerts...Using...
I had this occur on two 4402's in 1 week. Unexpected system reload based on uptime although no crash log, controller will not associate any NEW clients, existing clients OK, controller reports erroneous client count. Then after rebooting the contro...
Trying to figure out the CLI command for this under the GUI: Security, Priority Order, Management User, TACACS+If anyone knows can you post please for v4.1? Thanks.thanks
Has anyone had any client compatability issues when mixing 1242 and 1231 AP's within the same site? My older Symbol clients are freezing up etc when roaming to the 1242's while new clients are fine roaming within both flavors of AP's. The configs a...
This too has been the only effective way I've been able to get stubborn AP's back on their primary controller. I'm wondering if anyone has had better luck with the option 43?
I guess I'll reply to my own thread just to post what I've learned over the past few days in case it helps anyone else. A driver upgrade (actually the entire platform) on the MC9060's fixed their connectivity issues.My Zebra QL420 printers remain a ...
