Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have attempted to open three ports on our firewall. Only when I test the ports using an open port checker tool online, I get a response that the ports are closed. I'm not understanding why these ports are not getting hits or showing open. Can so...
I have a site to site vpn connection using two Pix devices. When I attempt to map a drive on a PC at the remote site to a Server at the main site it does not work. Also, I can not see the PC's on the network accross the VPN tunnel.Help!!!
Can someone explain the call path for calls going in and out of the following configuration?I have a 3662 with a DS1 card connected to an Avaya PBX on the local end. The remote end has a 3810 with (6) fxs cards in it. Each end is configured for all...
Recently we setup an isolated network for imaging HDD's. During this process we discovered that a 10Mb/sec hub had a better data transfer rate than a 10/100Mb/sec switch. This caused an old question to come screaming back to the forefront of my min...
Simrid,
I changed the access-list outside-access-in to:
access-list outside_access_in line 8 extended permit tcp any any eq 8099 (hitcnt=1) access-list outside_access_in line 9 extended permit tcp any any eq 8100 (hitcnt=1) access-list outside_access...
Apparently not. I get a command prompt when I run the command. Here is the complete configuration:
!interface Ethernet0/0 switchport access vlan 2!interface Ethernet0/1!interface Ethernet0/2!interface Ethernet0/3!interface Ethernet0/4!interface E...
