Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco WLC 8540Controller software : 8.5.135.0Assignment of Power & Channle : Auto What determines the power level, Is it only the APs bound to your controller or is it all the APs in the vaccinity? Dose channle assignment take account for other APs i...
Hello!I ran in to a wierd thing when i was lookin' thru some APs today and noticed 2 APs showing diffrent power lvl assignments but they are showing the same TxPower is that even possible? Can someone explain how this might happen? Running : Prime In...
Hey hey!I figured it out so could you take a look? To me theese look the same exept for the TX Power Lvls, Ch. & the nr of TX power lvl steps? But they should have the same restrictions no?Number Of Channels ........................ 0Tx PowerTx Power...
I don't understand what you're getting at here? To me they both look like they have the same restrictions?U-NII Mid / U-NII-2A 5.250–5.350 GHz 100 MHz 250 mW 1 Wch. 64 : U-NII Mid (U-NII-2A[3]): 5.250–5.350 GHz. Both outdoor and indoor use, subject...
ch. 64 : U-NII Mid (U-NII-2A[3] 5.250–5.350 GHz. Both outdoor and indoor use, subject to Dynamic Frequency Selection (DFS, or radar avoidance). Regulations allow for a user-installable antenna. Power limited to 250 mW. ch. 116 : U-NII Worldwide (U-N...
